FAQ

TOTAL 137 COUNT
122 Camera Q. Can I use DC-T1244WR for both license plate recognition and for surveillance purpose? 2018-07-09
A.

It cannot use for both purposes simultaneously.

Each good image quality for ANPR and for surveillance is defined differently as below, so we do not recommend to use the camera for both purposes at the same time.

Please refer to below and it is hard to control the image for surveillance via ANPR IP Camera.

 

"Good quality" image in general video surveillance.

- Wide dynamic range, deep depth of field, crisp image detail, good color saturation, anti-flickering, minimal motion blur, low noise, and hundreds of other criteria.

 

"Good quality" image in ANPR application.

- Best exposure.

- Tighter iris control if possible to achieve deeper depth of field.

- Shortest shutter speed to minimize the motion blur.

- Black and White for better license plate capture : even though there are enough ambient lights and even though you sacrifice the color information.

- Gain control to minimize the noise

 

121 Video Recorder Q. How to connect PoE switches to DR-8364? 2018-07-06
A.

A DR-8364 series NVR has video input ports which consists of two SFP ports and three RJ45 ports.

 

To prevent too much load on one RJ45 port, please distribute channels onto switches and connect each switch to each different RJ45 port as the image below shows.

 


 

Be aware of that connecting more than one RJ45 port to a same switch can create packet loop, so please separate links from each port. 

 

120 Video Recorder Q. What are the available resolution categories in IDIS TVI recorders? 2018-07-06
A.

Please refer to the table below.


 

119 Camera Q. How can I watch the recording video on a SD card? 2018-07-02
A.

There are three ways to play recorded data in a SD card, which are listed below.

 1) Access directly to the camera with the SD card through IDIS Web.

 2) Register the camera with the SD card to IDIS Center and access the camera.

 3) Put the SD card into a PC and run IDIS Center for iHDP to playback.

 

Please be aware of that NVRs cannot playback recorded data in SD cards of a camera.

 

118 Software Q. How many tabs can I use in IDIS Solution Suite Client and IDIS Center? 2018-06-29
A.

IDIS Center or IDIS Solution Suite Client can have maximum 4 Live tabs.

IDIS Center with 4 Live tabs give you a small video wall by separate tabs to each monitor.


 

 

However there is a  limitation on the number of tabs to create depending on Window OS. 

- 32bit OS: Maximum 2 tabs

- 64bit OS: Maximum 4 tabs

117 Camera Q. PoE power consumption of DC-S3583 and DC-S3883 series. 2018-06-25
A.

DC-S3583HRX and DC-S3883HRX are new speed dome camera models.

These speed dome cameras take more PoE power consumption than the existing speed dome camera models.

 

Power consumption of the popular speed dome models DC-S1263 and DC-S1283 series ranges from 10.6W to 24.3W(Heater on).

 

However, DC-S3583HRX and DC-S3883HRX take maximum 68.6W with heaters and IR LEDs on.

So common PoE switches with IEEE 802.3af or IEEE 802.3at cannot provide enough power for the cameras.

 

Please consider using the power adaptor provided in the package of the cameras or PoE injectors meet the power consumption of the cameras.

 

 

116 Software Q. How to use "Reconstruct" feature in IDIS Solution Suite to recover information in recorded data? 2018-06-04
A.

In case that a HDD has bad sectors and those sectors might corrupt time information in recorded data with a low possibility. This makes some recorded data invisible on Timetable.

 

To fix this, pelease execute “Reconsturct” feature in IDIS Solution Suite Setup.

The feature is to newly build time information table out of recorded data. The task of reconstructing time information will run in the background.


 

 

115 Software Q. We are going to do an internal test before we install ANPR(LPR) on a customer site. What is the specification required for ANPR Server? 2018-02-13
A.

The Server Specification is determined by the following procedure.

  1. First, check which country your customer site is located in, and check the number of lanes required for license plate recognition.
  1. Check the required score for it in the table below.
  2. Check the appropriate CPU at cpubenchmark.net
  3. Use 16GB or a higher memory card.

 


 

 

For example,

Assume that you are performing license plate recognition for three lanes in Europe, The required CPU score is 10710.

Visit the site below to find the cpu for the 10710. Intel Core i7-4790K or so.

http://www.cpubenchmark.net/high_end_cpus.html

 

The recommended server specification is as follows.

CPU : Intel Core i&-4790K or higher

RAM : 16GB RAM , But, if the number of ANPR engine is more than 2, 32GB RAM is recommended.

114 Software Q. I cannot watch live and playback image of the NVR in IDIS Solution Suite Client. 2017-12-12
A.


 

To connect to the ISS Expert, uPnP setting in the NVR and manual Port Forwarding to the router are required.

However, if you set only those settings, ISS(IDIS Solution Suite) Expert will give a private IP address of the NVR to ISS client over WAN network, and you will not be able to connect the NVR with the private IP address.

 

In this case, FEN service is the solution for the problem.

 

Register a NVR to FEN Server, FEN server will pass the both of IP addresses of NVR such as public and private to the client, it will make the client access the NVR correctly.

 

Then the Network configuration diagram looks like this.

 


 

113 Accessory Q. How many NVRs can be registered to IDIS Decoder? 2017-10-26
A.

DD-1116 supports 2MP resolution and H.264 codec and it can register up to 4 DirectIP NVRs. 

 

112 Camera Q. What Onvif profile do IDIS Cameras support ? 2017-10-26
A.

IDIS Cameras support Onvilf profile S.

You can find Onvif profile S specification from the below link.

 https://www.onvif.org/profiles/profile-s/

 

 

If you need Declaration of Conformance on IDIS cameras for Onvif compatibility, please visit www.onvif.org and go to Conformant Products.


 

111 General Q. Which NAT type does support FEN service ? 2017-10-26
A.

By creating a user custom name (FEN name) simply from a DirectIP NVR, its device info and

network parameters (including Device name, MAC address, IP address, port info, NAT type, product

info etc.) are automatically registered in the DirectIP FEN server running in the cloud. The user is

able to access the site remotely using this custom name instead of an IP address, as the FEN

server holds of the local device’s connection on the network even in a DHCP environment with

dynamic changing IP.

 

FEN service uses UDP hole punching for NAT traversal to gather address information of two ends, an NVR and a remote client, and NAT type in a site where an NVR is or a remote client is should support UDP communication.

 

 

[NAT types supporting UDP communication]

- Open internet

- Cone types (Full cone, Restricted cone, Port restricted cone)

 

[NAT types not supporting UDP communication]

- UDP blocked

- Symmetric

- Symmetric UDP firewall

 

110 Camera Q. How can I request 3rd party camera compatibility test? 2017-10-26
A.

To make 3rd party cameras to be compatible with our products, we need to go through the steps listed below.

 

We need below information with your request. 

(1) Model names and firmware version of 3rd party cameras to be tested with our products.

(2) Which IDIS product needs to be compatible to the 3rd party cameras.

(3. Expected business opportunity from that 3rd party camera integration.

(4) Due date for 3rd party cameras to be integrated with IDIS products.

 

Our sales department decides whether we proceed the integration or not.

When it is decided to proceed, we will provide IDIS 3rd Party Test Tool to check if the current operations of 3rd party cameras to our product. Please run the tool and send us the result. To get IDIS 3rd Party Test Tool, please contact IDIS Technical support team.

 

Lastly, send us at least two of the 3rd party cameras for us to integrate and test the cameras. 

 

 

109 Video Recorder Q. What are the status description of LED indicators on the front panel of NVRs? 2017-10-26
A.

Combinations of blinking status of Panic LED and Alarm LED on the front panel of NVRs indicate booting sequences.

 


 

108 Software Q. How to set User Alarm-in configuration on IDIS Solution Suite? 2017-09-19
A.

Please refer to the attachment for how to set up user alarm-in in IDIS Solution Suite